| |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[FW1] While we are on the subject of NAT
Hi,
My firewall ( firewall-1 ver 4.1 sp2 ) stops doing hiding NAT from time to
time for my internal network. After I reapply the policy it seems to sort it
out. If not I remove the network object for my internal LAN, save it, and
add it again with my hiding NAT address set. Then reapply the policy. This
fixes it aswell.
Has anyone had a similar experiance before and found a solution to it ?
This happens on both firewalls that I admin, it use to also happen while we
were using fw-1 ver 4.0 sp4. I was hoping 4.1 would solve this problem but
no luck yet.
These firewalls run on an ultra 10 and solaris 2.6 if that might help .
tx in advance.
E.
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================
|
|
