[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[FW1] RE: Very much a newbie question, FW-1 and Bay ARN
Ok never mind, I did not realize that my external interface was NOT enabled
for firewall. So I learned, always check your interfaces to make sure that
the FW Module is indeed bound to it and enabled.
> -----Original Message-----
> From: White, Steve (whites)
> Sent: Tuesday, October 31, 2000 11:44 AM
> To: 'Fw-1-Mailinglist (E-mail)
> Subject: Very much a newbie question, FW-1 and Bay ARN
>
>
> Ok I am a newbie to FW-1. I have a Bay ARN Router and have
> the FW-1 option enabled. I can load policies to the router no
> problem. However they only work on the outbound connection.
> If I load a policy that states drop all, and I test from the
> outside I have no problem getting in to my network. If I try
> to get out to the Internet from my local net, all packets are
> getting dropped as I expected. Like I said before I do not
> have much experience with FW-1. Currently the router is
> configured with two interfaces, my eth0 and my serial
> connection (ft0). The eth0 is my internal interface, and the
> FT0 connection is my external. I find this very strange as I
> figured with a total global packet drop that no packets
> should be allowed to cross the router at all. Any one have
> any experience with this particular setup? Thanks!
>
================================================================================
To unsubscribe from this mailing list, please see the instructions at
http://www.checkpoint.com/services/mailing.html
================================================================================