Re: [FW1] Very much a newbie question, FW-1 and Bay ARN

[CryptoTech <cryptotech@FW1-NOSPAMgmx.de>]

Steve,
Can you check to validate that the interfaces are all setup properly on the router
object?

"White, Steve (whites)" wrote:

> Ok I am a newbie to FW-1. I have a Bay ARN Router and have the FW-1 option
> enabled. I can load policies to the router no problem. However they only
> work on the outbound connection. If I load a policy that states drop all,
> and I test from the outside I have no problem getting in to my network. If I
> try to get out to the Internet from my local net, all packets are getting
> dropped as I expected. Like I said before I do not have much experience with
> FW-1. Currently the router is configured with two interfaces, my eth0 and my
> serial connection (ft0). The eth0 is my internal interface, and the FT0
> connection is my external. I find this very strange as I figured with a
> total global packet drop that no packets should be allowed to cross the
> router at all. Any one have any experience with this particular setup?
> Thanks!
>
> ================================================================================
>      To unsubscribe from this mailing list, please see the instructions at
>                http://www.checkpoint.com/services/mailing.html
> ================================================================================



================================================================================
     To unsubscribe from this mailing list, please see the instructions at
               http://www.checkpoint.com/services/mailing.html
================================================================================