[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [FW1] Routing Problem
Hi everybody. I am having a routing problem with a Solaris machine ( 2.5.1 ). My solaris box has 3 network interfaces and has the following oruitng table: Routing Table: Destination Gateway Flags Ref Use Interface -------------------- -------------------- ----- ----- ------ --------- 127.0.0.1 127.0.0.1 UH 0 37 lo0 148.243.163.133 172.16.1.30 UGH 0 3 172.18.0.0 172.16.1.11 UG 0 8 148.243.0.0 148.243.163.130 U 3 4 elx1 157.150.0.0 157.150.144.65 U 2 0 elx0 172.16.0.0 172.16.1.10 U 2 21 pcn0 224.0.0.0 148.243.163.130 U 3 0 elx1 default 148.243.163.129 UG 0 527 Here everything is ok ( I am doing static NAT for the IP 148.243.163.133 ). But I have one problem, as you can see all the packets addressed to the 157.144.0.0 net are going to be delivered by the elx0 interface ( private link ). But that is wrong because I just want the net 157.150.144.0 to go through that interface!! ( This is because the private link only has the 157.150.144 net and if I want ofr example to access the address 157.150.195.5 that packet has to go throuhg the elx1 interface and not to the elx0 interface. ) So what I did was to remove the entry from the routing table: route delete 157.150.0.0 157.150.144.65 And then to add: route add 157.150.144.0 157.150.144.65 So that packets addressed to the 157.150.144.0 network go through the 157.150.144.65 ( elx0 ) interface and other packets go through the elx1 interface. But it does not work!!! When I do this I ca not get any packets to the private link!! Any ideas??? I read somewhere that Solaris 2.5.1 can not have some special routing configurations, is this the case??? m -- Eduardo Frias [email protected] ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|