|
|
|
|
|
|
|
|
 |
 |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [FW1] LAN to LAN VPN with same IP scheme
That's going to be a problem. You could always renumber one of the networks, or possible NAT one of them to another, unused network. Either way you need to resolve the conflict, your client will never be able to route duplicates. -----Original Message----- From: Rodney Lacroix [mailto:[email protected]] Sent: Tuesday, October 17, 2000 12:18 PM To: [email protected] Subject: [FW1] LAN to LAN VPN with same IP scheme Can anyone tell me how you would configure two LAN's to communicate via VPN when each lan has the same network numbers? For example, network 1 is a 10.x.x.x network, and so is network 2 - therefore theoretically having duplicate IP addresses. How does the client know when to initiate a SecuRemote connection if it's destination address is the same as an address on the local LAN? Rodney Lacroix ============================================================================ ==== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ============================================================================ ==== ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|
||||||||||
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
