[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] [FW1] Two ISP connections to one Firewall
Hi I have been tasked with connecting a second E1 connection to a spare interface on an existing firewall, this circit will be from the same ISP as the existing line. The circuit will be connected via a second router and will use a second IP address. The circuits will not be acting as a single trunk. There is a requirement to configure the firewall so that traffic is split between the two on a protocol basis Has anyone managed to set this up successfully, is it possible and if so could you explain how to set this up, routing, rules etc. Regards Nic Trujillo Systems Management Centre Siemens IT Service A Division of Siemens plc, Registered No. 727817 Registered Office: Siemens House, Oldbury, Bracknell, Berks RG12 8FZ Direct Tel: +44 1344 850058 Fax: +44 1344 850810 Email: [email protected] This document and any attachments to it contain information that is private and confidential and should only be read by those persons to whom they are addressed. No person, without subsequent written confirmation of their contents, should rely upon the contents of this e-mail. This e-mail and the information it contains are supplied in good faith but Siemens Plc shall not be under any liability in damages or otherwise for any reliance that may be placed upon them by the recipient. Further, this document is sent for information and/or negotiating purposes only and shall not have the effect of creating a contract between the parties. If you have received this e-mail in error, please notify the sender(s) immediately by telephone. Please also destroy and delete the message from your computer. Any form of reproduction, dissemination, copying, disclosure, modification, distribution and/or publication of this e-mail is strictly prohibited save unless expressly authorised by the sender. ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|