|
|
|
|
|
|
|
|
 |
 |
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] Re: [FW1] Default Gateway Configuration for External and Internal Firewall interfaces
Assuming NT4, just use "route add 0.0.0.0 x.x.x.x -p" where x.x.x.x is your outside interface. There should be only one default route. ----- Original Message ----- From: "Frank" <[email protected]> To: "Thornton, Richard" <[email protected]> Cc: "Firewall-1 Mailing List (E-mail)" <[email protected]> Sent: Thursday, September 28, 2000 11:05 AM Subject: Re: [FW1] Default Gateway Configuration for External and Internal Firewall interfaces > > Configure default gateway ONLY on the external interface. > > Leave it blank on all other interfaces. > > > On Thu, 28 Sep 2000, Thornton, Richard wrote: > > > forwarding, i have not configured default gateways as I am not sure on the > > > > ================================================================================ > To unsubscribe from this mailing list, please see the instructions at > http://www.checkpoint.com/services/mailing.html > ================================================================================ ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|
||||||||||
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
