[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index] RE: [FW1] fetch
check $FWDIR/lib/control.map - ensure you are using the proper type of authentication if you want to force an auth type, you can put a comma-delimted line of the remote modules IP addresses at the top of this file. x.x.x.x, y.y.y.y: */fwa1 redo the putkeys on the clients and server: fw putkey -n local-ip -p [password] remote-ip -----Original Message----- From: [email protected] [mailto:[email protected]] Sent: Friday, September 08, 2000 5:37 PM To: [email protected] Subject: [FW1] fetch Just installed FW1 4.1 SP1 with FW on Solaris and Mgmt Server on NT 4.0. When FW starts up, it gets an error - "Authentication for command fetch failed" Any ideas? Bill Steele ============================================================================ ==== To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ============================================================================ ==== ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================ ================================================================================ To unsubscribe from this mailing list, please see the instructions at http://www.checkpoint.com/services/mailing.html ================================================================================
|