RE: [FW1] Hybrid IKE Securemote problem

[Chuck Melanson <chuck@FW1-NOSPAMmelancorp.com>]

I had this same problem, I had to to a combination fwstop / new cert /
fwstart and after a couple of iterations of either doing it with the fw
management console stopped / and then trying it with the fw management
console started, and then restarting it - the certs just showed up. -
but you are doing it correctly when it says that it created them.

Hope this helps!

CHuck

-----Original Message-----
From: Mark van Kerkwyk [mailto:mark@vk.net]
Sent: Thursday, September 07, 2000 5:14 AM
To: Firewall-1 Maillist
Subject: [FW1] Hybrid IKE Securemote problem



Hi,
     I'm having problems getting Hybrid IKE Securemote setup, I have
followed the CP document on it.

Running 4.1 and I have the following eval license.
10.10.10.10    30Sep2000  cpsuite-eval-des-v41 cprs:4.1:rs5
cpsuite-eval-des-v41 cprs:4.1:rs5 CK-EE0136198FC4

I have created the internalca (using fw internalca create -dn
"O=FRED,C=US") and certified the firewall object (fw internalca certify
-o
FW-MOF "O=FRED,C=US") , both appear to work successfully, but when I go
into the workstation object, there are no certs in the list, no is there
an
option to select Hybrid in the IKE workstation properties

Any ideas ?? Could there be a licensing issue, is a ca license required
??

Thanks

Mark



========================================================================
========
     To unsubscribe from this mailing list, please see the instructions
at
               http://www.checkpoint.com/services/mailing.html
========================================================================
========


================================================================================
     To unsubscribe from this mailing list, please see the instructions at
               http://www.checkpoint.com/services/mailing.html
================================================================================